Coolant Level
- jamespope
- Forum Contributor
- Posts: 40
- Joined: Wed May 20, 2015 10:31 am
- Car Details: D3 TDV6 GS A 2008
- Location: Manchester
Coolant Level
Hi All,
Just wondering if anyone has come across similar issue to one i'm having at the moment.
I've recently had a new fuel cooler fitted as some corroded hose tails on the old one were causing a slow coolant leak. Since the repair has been completed, I get a low coolant level message on the dash - when (and only when) I've put my foot on the floor for a bit. The message then clears after 2 or so minutes of normal driving.
I've read all about this longstanding issue with the float in the coolant bottle, but I can't see that being the issue with it only happening when I put my foot down, and then clearing again - i.e. presumably a sunk float would stay sunk.
There is plenty of coolant in the system by the way - if anything its a bit overfilled.
Anyone come across anything similar?
I'm going to short the sensor out tonight and give it a blast on the motorway to see if i can rule out a wiring issue but otherwise i'm at a loss. Next step would be to see if I can wedge a go-pro in there somewhere to keep an eye on the actual coolant level to make sure its not dropping below the minimum for some reason.
Cheers in advance
James
Just wondering if anyone has come across similar issue to one i'm having at the moment.
I've recently had a new fuel cooler fitted as some corroded hose tails on the old one were causing a slow coolant leak. Since the repair has been completed, I get a low coolant level message on the dash - when (and only when) I've put my foot on the floor for a bit. The message then clears after 2 or so minutes of normal driving.
I've read all about this longstanding issue with the float in the coolant bottle, but I can't see that being the issue with it only happening when I put my foot down, and then clearing again - i.e. presumably a sunk float would stay sunk.
There is plenty of coolant in the system by the way - if anything its a bit overfilled.
Anyone come across anything similar?
I'm going to short the sensor out tonight and give it a blast on the motorway to see if i can rule out a wiring issue but otherwise i'm at a loss. Next step would be to see if I can wedge a go-pro in there somewhere to keep an eye on the actual coolant level to make sure its not dropping below the minimum for some reason.
Cheers in advance
James
-
- Forum Contributor
- Posts: 1
- Joined: Mon Jun 05, 2017 3:40 pm
- Car Details: 08 D3 HSE
- Member Since: 26 Sep 2017
Re: Coolant Level
Faulty sensor in expansion tank.
I had the same problem I'm now on my second tank in six months
I had the same problem I'm now on my second tank in six months
-
- Forum Contributor
- Posts: 29
- Joined: Tue May 17, 2016 10:26 pm
- Car Details: Discovery 3
- Location: Londonderry Australia
Re: Coolant Level
When you "floor" it the water pump circulates the water more and if there is a air pocket the coolant level will go down as soon as you take your foot off the level will come back up. It is possible that you need to bleed the system well to remove all air that is trapped.
- jamespope
- Forum Contributor
- Posts: 40
- Joined: Wed May 20, 2015 10:31 am
- Car Details: D3 TDV6 GS A 2008
- Location: Manchester
Re: Coolant Level
I had wondered about air in the system, i'll have a look on the web for bleed procedures and give it a go - thanks for the suggestion.
- Bodsy
- Chairman
- Posts: 12224
- Joined: Mon Feb 15, 2010 1:37 pm
- Winner: Technical Post 2012, 2013
Comedian of the Year 2014 - Car Details: 2007 HSE
- Member Since: 15 Feb 2010
- Location: Sunny Shropshire!
Re: Coolant Level
It’s just the water flow is more when you accelerate, so with a porous ‘float’ it’s sinking already and then sinks more when the water forces it to.
Only fix is replacement coolant bottle.
Only fix is replacement coolant bottle.
Check http://tinyurl.com/brakebible
Here for How to change your Brake Pads, Disks, EPB Shoes Adjust, removal, cleaning & fitting Guide.
IID Pro Multivehicle. D3, D4, RRSport pre and post 2010, FFRR.
Gearbox Transmission Flushes and much more
Disco3Club Chairman
Here for How to change your Brake Pads, Disks, EPB Shoes Adjust, removal, cleaning & fitting Guide.
IID Pro Multivehicle. D3, D4, RRSport pre and post 2010, FFRR.
Gearbox Transmission Flushes and much more
Disco3Club Chairman
- PillowSmuggler
- Committee Member
- Posts: 7587
- Joined: Wed Apr 07, 2010 8:17 am
- Winner: Avatar of the Year 2012
Comedian of the Year 2013
Mechanic of the Year 2014
Clube Member of the Year 2014 - Car Details: Disco3 TDV6 HSE 2007
- Member Since: 29 Jun 2013
- Location: http://goo.gl/maps/WGOsq
Re: Coolant Level
James, last time I changed my bottle I used some hose clamps and didn't drain the rest of the engine. It's an option, just thought i'd mention it.
Regards, Dom.
2007 HSE Auto TDV6
Snorkel, Cyclonic air filter, GNVP Rock Sliders
78Ah Aux, Split charge, FBH Timer/Remote, Mantec sump plate
LED: Strobes, interior, camping, brake, running, sides
New Oil Pump, using 2SO at 1:400.
2007 HSE Auto TDV6
Snorkel, Cyclonic air filter, GNVP Rock Sliders
78Ah Aux, Split charge, FBH Timer/Remote, Mantec sump plate
LED: Strobes, interior, camping, brake, running, sides
New Oil Pump, using 2SO at 1:400.
- jamespope
- Forum Contributor
- Posts: 40
- Joined: Wed May 20, 2015 10:31 am
- Car Details: D3 TDV6 GS A 2008
- Location: Manchester
Re: Coolant Level
Thanks Dom!
I was planning something along those lines, its probably inevitable that it will get a 'gulp' of air in one of the hoses in the process though - hence my reading up on bleeding procedures. By the sounds of it I just need to:
- Refill the bottle
- start car and let it get up to temperature (doing the 1 min at 3000rpm, 5 min at idle etc etc routine)
- Take the cap off the coolant bottle (very carefully)
- refill as needed
Might video the whole affair and stick on you tube for posterity's sake. Or at least so there's a record of my death.
Cheers,
James
I was planning something along those lines, its probably inevitable that it will get a 'gulp' of air in one of the hoses in the process though - hence my reading up on bleeding procedures. By the sounds of it I just need to:
- Refill the bottle
- start car and let it get up to temperature (doing the 1 min at 3000rpm, 5 min at idle etc etc routine)
- Take the cap off the coolant bottle (very carefully)
- refill as needed
Might video the whole affair and stick on you tube for posterity's sake. Or at least so there's a record of my death.
Cheers,
James
- anglefire
- Site Admin
- Posts: 19327
- Joined: Sat May 15, 2010 8:01 pm
- Winner: Club Member of Year 2012 & 13
- Car Details: Skoda Enyaq IV 80
- Member Since: 17 May 2010
- Location: Solihull, West Midlands
- Contact:
Re: Coolant Level
That sounds about right - bleed screw may need to be opened on top of the engine if you loose alot - but if its only a bit, I wouldn't even bother with the revvy bit - just drive it and check the level regularly until you are happy.
Last time I had to fill mine was 6000' up a mountain after the top spider decided to split at 8000' - Added a couple of gallons of water/antifreeze did the bleed procedure and all was well again!
Last time I had to fill mine was 6000' up a mountain after the top spider decided to split at 8000' - Added a couple of gallons of water/antifreeze did the bleed procedure and all was well again!
Mark
Waeco CFX 40
1977 Triumph Spitfire 1500
Skoda Enyaq IV 80
Skoda Superb SE L Ex (Gone)
2006 disco3 SE. Gone but not forgotten.
BMW 530d M Sport Touring. Gone
Member of Admin team and
Disco3Club Photos: Here
Waeco CFX 40
1977 Triumph Spitfire 1500
Skoda Enyaq IV 80
Skoda Superb SE L Ex (Gone)
2006 disco3 SE. Gone but not forgotten.
BMW 530d M Sport Touring. Gone
Member of Admin team and
Disco3Club Photos: Here